Why does the laser cutting machine reset abnormally?

3. The beam resets normally, but the X-axis of the laser cutting machine does not reset. The motor wire or the motor shaft may be broken. In this case, the motor wire or the small motor should be replaced.

4. The direction is correct when resetting, but when it reaches the apex, the X-axis or Y-axis cannot stop (check the mainboard parameters first). If it is correct, check the mainboard or sensor for this phenomenon, and replace it.
Why does the Metal Laser Cutting Machine reset abnormally?
When encountering this situation, we can generally try to solve it in the following ways:
1. Check the sensor for dust, poor contact or damage (wipe off the dust on the sensor or replace it);
2. Check whether the flexible conductive tape data cable is in poor contact or damaged (trim the data cable and re-plug or replace the data cable);
3. Check whether the ground wire contact is reliable or whether the high-voltage wire is damaged (re-ground or replace the high-voltage wire);
4. Poor contact of the motor wire (replace the motor wire or a small motor).
The article is provided by: laser cutting machine Guangdong Chittak Intelligent Equipment Co., Ltd.